SKF PER.G206HPPB4 y-bearing (insert bearing)

SKF PER.G206HPPB4 belongs to y-bearing (insert bearing), part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PER.G206HPPB4 and any equivalents.

The SKF PER.G HPPB series covers Y-bearing inserts that combine a spherical outer ring with a quick fastening system. They are made for split plummer block housings and complete bearing units, and they suit equipment that needs to be assembled or removed without special tooling while tolerating minor misalignment. MR Industrial Accessories supplies this line and can help you match the insert to your shaft and housing.

Reading the designation in order is the fastest way to understand what you are looking at. The PER.G portion points to the insert family that uses a spherical outer ring and set screw locking. The letter G followed by a number gives the shaft diameter, expressed in inches or millimeters depending on the variant. The HPPB block describes the seal arrangement and insert configuration, and the trailing digit, as seen in PER.G206HPPB4 or PER.G207HPPB2, separates versions within one size. Because not every combination is produced for every diameter, confirming the full part number before ordering avoids a mismatch.

Typical installations include conveyors, belts, elevators, mixers, fans and agricultural equipment. In food plants, packing houses and metalworking shops, dust, moisture or washdown make sealing quality a deciding factor. Since these are inserts, they seat in split plummer block housings or complete units, which makes replacement easier on long or hard-to-reach shafts. They are also a practical choice when the shaft and housing are not perfectly aligned.

Selection starts with the shaft diameter and the housing type. The HPPB seal is intended to hold grease in and keep contaminants out, so in wet or dusty conditions it pays to inspect the lip and the clearance. Set screw fastening means tightening against the inner ring with the correct wrench and making sure the shaft surface is free of burrs. Use a compatible grease and check housing alignment; the spherical outer ring absorbs slight misalignment, but forcing the fit will shorten service life.

Several brands offer inserts with a spherical outer ring and set screw locking, each with its own nomenclature, and there is no universal cross-reference. The same shaft diameter can differ in width, sealing or fastening method. If you are replacing a Y-bearing, send the complete part number along with the shaft dimensions so we can point you to the closest alternative.

For part numbers such as PER.G206HPPB4, PER.G207HPPB2 or any other variant in the series, send the number via WhatsApp together with a photo of the housing and the shaft dimensions. MR Industrial Accessories quotes SKF bearings and helps you confirm the right version before you buy.