V-belt Optibelt X17 x 1790
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- BX
- Series
- Super TX M=S
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT X17 x 1790 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for X17 x 1790 and any equivalents.
The Optibelt Super TX M=S is a cogged classical V-belt built for drives where a standard wrapped belt runs hot or slips under load. This belt is profile BX with a length of 1790 mm, identified by the code X17 x 1790. Use it as a direct replacement when the drive calls for a BX profile belt of that length.
Cogged classical V-belts are common on industrial drives such as pumps, fans, compressors and process machinery, where the molded cogs improve flexibility around smaller pulleys and help heat escape from the belt body. The BX profile is the narrow cross-section in this family, so it suits compact drives that still need the grip of a classical V-belt.
To confirm fit, read the marking on the back of the old belt and match both the profile and the length. The profile must be BX and the length must be 1790 mm. Also check the pulley groove for wear, alignment and any debris before installation, and replace belts in a set together so the load stays evenly shared.
If you are unsure whether this is the correct belt for your drive, send the part number X17 x 1790, the profile and length from the old belt, and the equipment make and model. Our team will confirm the match and help you select the right cogged classical V-belt.
Dimensions
- Section
- BX
- Length
- 1790mm
Frequently asked questions
- What does the code X17 x 1790 mean on this Optibelt belt?
- It is the manufacturer's designation for this belt. The profile is BX and the length is 1790 mm. Use both values when comparing against the marking on your existing belt.
- How do I confirm this belt fits my drive?
- Check that your drive uses a BX profile belt and measure the outside length as 1790 mm. Match those two figures to the belt you remove, and inspect the pulleys for wear or misalignment before fitting the new belt.
- What should I send to request a quote for this belt?
- Send the part number X17 x 1790, the profile BX and the length 1790 mm. If you are replacing an existing belt, include a photo of the back marking and the equipment make and model so we can confirm the match.