V-belt Optibelt 10 x 710 Li
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- Z
- Series
- VB S=C Plus
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 10 x 710 Li belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 10 x 710 Li and any equivalents.
This Optibelt VB S=C Plus belt is a classical V-belt with profile Z and a length of 710 mm. The marking 10 x 710 Li identifies the belt for selection and replacement.
The profile and length are the two values that matter most when matching a belt to a drive. Profile Z sets the cross-section that must sit correctly in the pulley groove, and 710 mm is the datum length used to confirm the belt fits the drive layout. Both are stated on the belt and should be checked against the old part before ordering.
The VB S=C Plus series is built for classical V-belt drives where a standard cross-section is required. If the existing belt is worn, glazed, or has visible cracks, replacing it before failure helps avoid unplanned downtime. For drives using more than one belt, inspect all belts in the set and replace them together so the load stays evenly shared.
To request a quote, send the part number 10 x 710 Li, or the profile and length from the back of the belt, by WhatsApp or email. Our team replies promptly and can confirm the right belt or suggest an equivalent from the lines we carry.
Dimensions
- Section
- Z
- Length
- 710mm
Frequently asked questions
- What do the profile and length tell me about this belt?
- Profile Z defines the cross-section that fits the pulley groove, and 710 mm is the length used to match the drive. Both values are marked on the belt and should match the part being replaced.
- How do I read the marking on the back of the belt?
- The marking 10 x 710 Li gives the profile and length for this Optibelt VB S=C Plus belt. Use those values to confirm the replacement before ordering.
- What should I send to request a quote?
- Send the part number 10 x 710 Li, or the profile and length from the old belt, by WhatsApp or email. The team can confirm the right belt or suggest an equivalent.