V-belt Gates SPZ 730 MN

GATES SPZ 730 MN belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPZ 730 MN and any equivalents.

This page covers the Gates SPZ 730 MN, a narrow wedge V-belt in the Super HC MN series. If you are replacing a worn belt, the marking on the back of the old belt is the starting point for matching it. Confirm the profile and the length before you request a quote.

The SPZ 730 MN is a narrow wedge V-belt with an SPZ profile and a length of 730 mm. It measures 9.7 mm across the top, stands 8 mm high, and its flanks are cut at 40 degrees. Those four values identify the belt: profile, length, top width, height and angle. When you read the back of the belt being replaced, compare each value against this data rather than relying on a general description.

A narrow wedge V-belt sits deeper in the groove than a classic V-belt of the same top width, so the profile marking matters as much as the length. Check that the old belt shows SPZ and 730 mm, and check the drive for worn sheaves, misalignment or a belt that has been running slack. If the old marking is faded or missing, measure the outside length and the top width and send those numbers with a photo of the belt and the drive.

To request a quote, send the part number Gates SPZ 730 MN by WhatsApp or email. If you are unsure whether this is the correct belt, send the marking from the old belt, the profile and length you measured, and the machine or drive it runs on. The team replies promptly and can confirm the right belt or suggest an equivalent.