V-belt Stark A 60
- Brand
- STARK
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
DODGE and STARK: matching part numbers →GATES and STARK: matching part numbers →MITSUBOSHI and STARK: matching part numbers →OPTIBELT and STARK: matching part numbers →
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
STARK A 60 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for A 60 and any equivalents.
The Stark A 60 is a classical V-belt with an A profile, a 13 mm top width, an 8 mm height, and a 40° angle. It is used in industrial drives where a standard classical V-belt is specified. To match it to the belt being replaced, confirm the profile and the length on the old belt.
The easiest way to match this belt is to read the marking on the back of the belt you are replacing. If it shows an A profile and the same length, the Stark A 60 is the correct profile and size. The same size is also listed under Mitsuboshi A 60 and Optibelt A 60, so you can compare those markings directly if your old belt carries a different brand.
Before ordering, inspect the drive for worn sheaves, misalignment, or damaged guards. A new belt will not correct those conditions. If you are replacing more than one belt on a multi-belt drive, replace the full set at the same time so the load is shared evenly.
For a quote, send the part number A 60, the quantity, and a photo of the marking on the old belt if it is readable. If the marking is worn, measure the top width and the outside length and send those values. We carry the Stark A 60 and can help confirm it is the right belt for your drive.
Dimensions
- Section
- A
Frequently asked questions
- How do I confirm the Stark A 60 is the right replacement?
- Check the marking on the back of the belt being replaced. It should show an A profile and the same length. If the marking is not readable, measure the top width and the outside length of the old belt and compare them to the 13 mm top width and the length of the A 60.
- Can I replace just one belt on a multi-belt drive?
- On a drive that uses more than one belt, replace the full set at the same time. Mixing a new belt with worn belts can cause uneven load sharing and shorten belt life.
- What information should I send with my quote request?
- Send the part number A 60, the quantity you need, and a photo of the marking on the old belt if it is readable. If the marking is worn, include the measured top width and outside length.