V-belt Movendis PP-XPA1850-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- XPA
- Series
- PowerPlus EPDM Cogged Raw Edge Narrow
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-XPA1850-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-XPA1850-EPDM-AS and any equivalents.
This is a Movendis PowerPlus EPDM Cogged Raw Edge Narrow belt, a cogged narrow V-belt in the XPA profile with a length of 1850 mm. Cogged narrow V-belts are used on industrial drives where a compact cross-section is needed to transmit load, typically on pumps, fans, compressors and similar driven equipment.
To confirm fit, read the marking on the back of the old belt and compare it with the part number and profile shown here. The two values that matter for matching are the profile, XPA, and the length, 1850 mm. Measure the old belt only if the marking is no longer readable.
Because this is a raw edge cogged construction, the belt is built for drives that run over relatively small pulleys. Check the pulley grooves for wear, oil or debris before fitting, and confirm the belt sits correctly in the groove rather than riding on the flanks. If a drive uses more than one belt, replace the full set so the load stays evenly shared.
Dimensions
- Section
- XPA
- Length
- 1850mm
Frequently asked questions
- What does the marking on my old belt tell me?
- The marking identifies the profile and the length. Match it to the XPA profile and 1850 mm length given for this Movendis belt. If the marking is worn off, measure the outside length and send that with a photo of the belt and pulley.
- How do I request a quote for this belt?
- Send the part number PP-XPA1850-EPDM-AS by WhatsApp or email. If you are not certain of the number, send the marking from the old belt or its measured length and profile, and the team can confirm the right belt or suggest an equivalent.
- Should I replace one belt or the whole set?
- On a multi-belt drive, replace all belts in the set at the same time. Mixing a new belt with worn belts changes how the load is shared across the grooves and shortens the life of the new belt.