V-belt Movendis PP-XPA1857-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- XPA
- Series
- PowerPlus EPDM Cogged Raw Edge Narrow
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-XPA1857-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-XPA1857-EPDM-AS and any equivalents.
The Movendis PP-XPA1857-EPDM-AS is a cogged narrow V-belt in the XPA profile with a length of 1857 mm. The profile and the length are the two numbers that decide whether this belt fits your drive, so check both against the belt you are replacing.
XPA is a narrow, wedge-type profile, and this belt is a cogged raw edge construction, which is the form used on smaller pulley diameters where a wrapped belt would run hot. The 1857 mm length is the datum you match against the old belt. If your drive was built around an XPA section, this is the correct family; the 1857 mm figure then sets the position of the tensioner and the take-up you have to work with.
The simplest way to confirm the match is to read the marking on the back of the belt you are removing. If it shows XPA and 1857, this belt is the direct replacement. If the back of the belt is worn or the marking is gone, measure the outside length and note the profile from the pulley groove width, then send both figures to us.
For a quote, send the part number PP-XPA1857-EPDM-AS, or send the profile and length from your old belt and we will confirm the right belt or suggest an equivalent. If a drive runs more than one belt, order the full set so the belts share the load evenly.
Dimensions
- Section
- XPA
- Length
- 1857mm
Frequently asked questions
- What do the XPA profile and 1857 mm length mean for my drive?
- XPA is the narrow wedge profile of the belt, and 1857 mm is its length. Both must match your drive: the profile has to sit correctly in the pulley grooves, and the length has to give the tensioner its working range.
- How do I confirm this is the belt I need?
- Read the marking on the back of the belt you are replacing. If it shows XPA and 1857, this belt matches. If the marking is unreadable, measure the outside length and check the pulley groove width for the profile.
- How do I request a quote?
- Send the part number PP-XPA1857-EPDM-AS by WhatsApp or email. If you are unsure of the number, send the profile and length from your old belt and we will confirm the right belt or suggest an equivalent.