V-belt Movendis PP-SPB1650
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPB
- Series
- PowerPlus Narrow Wedge V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-SPB1650 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-SPB1650 and any equivalents.
The Movendis PP-SPB1650 is a narrow wedge V-belt in the SPB profile, 1650 mm long, with a 16.3 mm top width, 13 mm height and a 40 degree angle. Before you fit it, inspect the drive so the new belt is not damaged by worn components. We carry this belt and quote it by part number.
Check the sheaves first. Look for worn grooves, grooves with a polished or stepped floor, nicks on the flanges and any burrs that would cut the belt sidewalls. A sheave worn past its groove angle will let an SPB belt sit too deep, so it slips and runs hot even when the belt is new. Measure groove wear with a sheave gauge, and replace sheaves that are out of tolerance before you install the belt.
Then check alignment and tensioning. Misalignment between shafts, a bent or worn bushing, or a loose motor base will pull the belt to one side and shorten its life. With the belt off, turn the driven equipment by hand to confirm the bearings run free, and remove any debris or buildup in the grooves. Set tension to the drive manufacturer's specification rather than by feel.
The PP-SPB1650 is part of the Movendis PowerPlus line of narrow wedge V-belts. The profile is SPB, the length is 1650 mm, the top width is 16.3 mm, the height is 13 mm and the angle is 40 degrees. If you are replacing a belt on a multi-belt drive, send the full set of part numbers so we can quote them together.
Dimensions
- Section
- SPB
- Length
- 1650mm
Frequently asked questions
- What are the dimensions of the Movendis PP-SPB1650?
- It is an SPB profile narrow wedge V-belt, 1650 mm long, with a 16.3 mm top width, 13 mm height and a 40 degree angle.
- Why should I check the sheaves before fitting this belt?
- Worn or misaligned sheaves let a new SPB belt sit incorrectly, which causes slip and heat. Inspect the grooves, flanges and alignment first, and correct anything out of tolerance.
- How do I request a quote for this belt?
- Send the part number PP-SPB1650 by WhatsApp or email. If you are ordering for a set, include the quantity and any other part numbers on the same drive.