V-belt Movendis P-A85
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-A85 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-A85 and any equivalents.
The Movendis P-A85 is a classical wrapped V-belt with an A profile and a length of 2160 mm. Before you fit it, inspect the drive and sheaves so the new belt runs true from the first start.
Check sheave grooves for wear, rust, or embedded debris, and confirm the grooves match the belt's A profile. Measure the groove width and look for a step or ridge where the belt has been running; a worn groove lets the belt sit too deep and slip. Also check sheave alignment with a straightedge or laser, and correct any offset or angular misalignment before fitting the P-A85.
Inspect the rest of the drive: bearings for play or rough rotation, shafts for runout, and guards for contact or rubbing. Confirm the belt length you need by reading the marking on the back of the old belt and comparing it with 2160 mm. The P-A85 has a top width of 13 mm, a height of 8 mm, and a 40° angle, so it seats in standard A-profile grooves.
If the drive uses more than one belt, replace the full set at the same time and keep the belts matched as a set. Clean the grooves, check tension after the first run-in, and recheck it once the belt has seated. Send the part number P-A85 by WhatsApp or email to request a quote.
Dimensions
- Section
- A
- Length
- 2160mm
Frequently asked questions
- What are the dimensions of the Movendis P-A85?
- It is an A-profile classical wrapped V-belt with a length of 2160 mm, a top width of 13 mm, a height of 8 mm, and a 40° angle.
- What should I check before fitting this belt?
- Inspect the sheave grooves for wear or debris, verify alignment, check bearings and shafts, and confirm the required length against the marking on the old belt.
- How do I request a quote for the P-A85?
- Send the part number P-A85 by WhatsApp or email. The team can confirm the belt or suggest an equivalent.