V-belt Movendis P-A100.5
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-A100.5 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-A100.5 and any equivalents.
The Movendis P-A100.5 is a classical wrapped V-belt in an A profile, with a 2550 mm length, 13 mm top width, 8 mm height and a 40° angle. Classical wrapped V-belts like this are commonly used on drives where the belt runs in a matched groove and carries power between two pulleys. To confirm it fits your drive, check the profile and length against the old belt or the machine's belt specification before ordering.
The P-A100.5 belongs to the Movendis Classical Wrapped V-Belts series. Its A profile and 2550 mm length identify the cross-section and the outside length, while the 13 mm top width, 8 mm height and 40° angle describe the belt's shape as it seats in the pulley groove. These values are the ones to match when comparing the belt on your equipment.
When replacing a classical V-belt, read the marking on the back of the old belt and compare it with the profile and length above. If the marking is worn or missing, measure the belt cross-section and the length, and note how many belts run on the drive. Send the part number, the machine details and any photos of the old belt so we can confirm the correct belt or suggest an equivalent.
Inspect the pulleys at the same time. Worn grooves, oil or debris can shorten belt life, and a belt that is too loose or too tight will not run correctly. If the drive uses more than one belt, replace them as a set so the load stays evenly distributed.
Dimensions
- Section
- A
- Length
- 2550mm
Frequently asked questions
- How do I confirm the Movendis P-A100.5 fits my drive?
- Match the A profile and the 2550 mm length to the belt you are replacing, and check the 13 mm top width, 8 mm height and 40° angle against the pulley groove. If you are unsure, send the part number and photos of the old belt and we will help confirm it.
- What should I send to get a quote for this belt?
- Send the part number P-A100.5, the quantity you need and the machine or application details. If you have the old belt, include a photo of the back marking and the cross-section so we can verify the profile and length.
- Should I replace more than one belt at a time?
- If your drive uses multiple belts, replace them as a set. Belts that have run for different lengths of time can differ in length, which affects how the load is shared across the drive.