V-belt Gates SPZ 1937 MN

GATES SPZ 1937 MN belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPZ 1937 MN and any equivalents.

The Gates SPZ 1937 MN is a narrow wedge V-belt in the Super HC MN series. It is identified by profile SPZ and length 1937 mm, with a top width of 9.7 mm, a height of 8 mm and a 40-degree angle. Use these markings to match it to the belt you are replacing.

When a drive is down, the fastest way to confirm the correct replacement is to read the belt you are removing. Look for the profile and the length on the back of the old belt and compare them with the SPZ profile and 1937 mm length of this Gates SPZ 1937 MN. The top width of 9.7 mm, height of 8 mm and 40-degree angle give you the cross-section details to check against the old belt and the pulley grooves.

If the old belt is worn, glazed or has lost its marking, measure the outside length and check the pulley groove width. The SPZ profile is a narrow wedge section, so the groove must match that section rather than a classic V-belt. When a drive uses more than one belt, replace the full set at the same time so the belts share the load evenly.

We carry the Gates SPZ 1937 MN for maintenance and purchasing teams in the US, Canada, Mexico and South America. Send the part number by WhatsApp or email and our team will confirm the belt or suggest an equivalent. Including the old belt marking, the drive make and model, and the pulley diameters helps us reply promptly.