V-belt Gates SPZ 1450 MN
- Brand
- GATES
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPZ
- Series
- Super HC MN
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
GATES SPZ 1450 MN belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPZ 1450 MN and any equivalents.
The Gates SPZ 1450 MN is a narrow wedge V-belt from the Super HC MN series. It is built for industrial drives that need a compact, high-capacity belt. This page covers where this profile is used and how to confirm it fits your drive.
Narrow wedge V-belts like the SPZ profile are common on pumps, fans, compressors, and other driven equipment where space at the pulley is limited. The SPZ profile has a 9.7 mm top width, 8 mm height, and a 40-degree angle. The belt length is 1450 mm. Because the profile is narrower than a classic V-belt, it fits pulleys designed for SPZ grooves.
To confirm fit, check the marking on the old belt and match the profile and length. The Gates SPZ 1450 MN is identified by the code SPZ 1450 MN. If the old belt is worn or the marking is unreadable, measure the top width and the outside length, then compare with the values above. Also inspect the pulleys for wear, alignment, and correct groove profile.
When replacing belts on a multi-belt drive, install a full set of the same profile and length so the load is shared evenly. Keep the drive clean and check tension after the first run-in period. If you need help confirming the right belt, send the part number and a photo of the old belt marking to our team.
Dimensions
- Section
- SPZ
- Length
- 1450mm
Frequently asked questions
- What is the profile and length of the Gates SPZ 1450 MN?
- The belt has an SPZ profile and a length of 1450 mm. The top width is 9.7 mm, the height is 8 mm, and the angle is 40 degrees.
- How do I confirm this belt fits my drive?
- Match the profile and length to the old belt or to the drive requirements. Check the marking on the back of the old belt for SPZ and 1450. If the marking is not clear, measure the top width and outside length and compare with the values above.
- Can I use this belt on a drive that originally used a different profile?
- No. Use a belt that matches the pulley groove profile. The SPZ profile is designed for SPZ pulleys. Mixing profiles can cause poor performance and premature wear.