DBH 9532Sil radial shaft seal — 50.6 x 71.4 x 14

DBH 9532Sil belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9532Sil and any equivalents.

The DBH 9532Sil is a radial shaft seal that sits between a turning shaft and a stationary housing, holding lubricant in and keeping dust, water and particles out. Its Mz design is a single lip with a spring, intended for rotating shafts under permanent lubrication. The three dimensions to match are shaft 50.60 mm, housing 71.40 mm and height 14.00 mm, which places it in medium-section shaft work.

Reading the code is the fastest way to confirm a fit. The 9532Sil designation identifies the item in the DBH line, and the Mz marking tells you the sealing principle. Before ordering, compare all three values against your equipment: shaft 50.60 mm, housing 71.40 mm and height 14.00 mm. If any one of them is off, the seal will not seat or seal correctly, so it pays to measure the old part rather than assume.

You will find this seal in gearboxes, centrifugal pumps, electric motors, conveyor rollers and other power transmission equipment. In every case it does the same job: it keeps oil or grease where it belongs and blocks outside contamination from reaching the internals. Treat it as a wear part. Lubricant weeping at the seal area, or new noise and vibration around it, are signs that replacement is due before nearby bearings or gears take damage.

Installation is straightforward if the basics are respected. Check that the shaft and housing diameters match the values above, that the shaft is free of burrs and wear, and that the sealing surface is clean. Lubricate the lip before pressing the seal in, and orient the lip toward the fluid side. If your equipment runs at high peripheral speed or elevated temperature, ask us about material and design variants before you request a quote.

When you need a substitute, send the code 9532Sil along with the shaft, housing and height dimensions and the equipment brand. With that information we check the DBH line and other compatible options. We can also tell you whether the Mz design suits your application or whether a different lip type or material would serve you better.

To get a quote for the DBH 9532Sil, message us on WhatsApp or by email with the part number and the quantity you need. We supply this brand and can help you confirm the application and the mounting. If the dimensions or an equivalent are in doubt, a photo of the old part or of the housing is usually enough for us to review it with you.