DBH 9096 radial shaft seal — 19 x 42 x 7

DBH 9096 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9096 and any equivalents.

The DBH 9096 is a radial shaft seal built to keep lubricant in and contaminants out of rotating shaft assemblies. It is sized for a 19 mm shaft, a 42 mm housing bore and a 7.00 mm height, and its Lx lip and outer body configuration make it a press-fit component that runs against the shaft surface. You will find seals like this in pumps, motors, gearboxes and other power transmission equipment, where they protect bearings and gears from oil loss, dust and water ingress.

This seal carries the designation 9096 and belongs to the DBH radial shaft seal family. Its dimensions are shaft 19 mm, housing bore 42 mm and overall height 7.00 mm. The Lx design refers to the lip and outer body arrangement. It is a radial-type seal: the outer body is pressed into a fixed housing while the flexible lip rides on the rotating shaft.

Typical service locations include centrifugal pumps, electric motors, gear reducers and gearboxes, compressors, fans and similar power transmission machinery. In each case the seal performs two jobs: retaining oil or grease inside the assembly and blocking dust, chips or water from entering. Because it sits between the lubricant and the environment, it directly affects the service life of adjacent bearings and gears.

When installing a radial shaft seal, confirm that the shaft diameter and housing bore match the values above. Lubricate the lip before sliding the shaft through, and use an installation tool that presses on the outer edge rather than the lip. Shaft runout and the finish of the surface under the lip influence sealing performance. If the shaft shows wear, a seal with an additional lip may be an option to consider.

If you need an equivalent to the DBH 9096, the most practical step is to send the complete code along with the shaft, housing and height dimensions. With that information we can search for an alternative from another brand in the same radial shaft seal category. It also helps to specify the lubricant type and operating temperature, as these guide the choice of lip material. Our team can assist you in finding the right option.

To request a quote for the DBH 9096 seal, contact us on WhatsApp or by email and include code 9096 with the dimensions. We will verify the exact size and, if needed, suggest a compatible alternative. MR Industrial Accessories supplies this brand and can advise on installation and seal selection for your equipment.