DBH 8024Vit radial shaft seal — 30 x 45 x 8

DBH 8024Vit belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 8024Vit and any equivalents.

When a rotating shaft starts weeping oil, the first thing to check is the lip seal. The DBH 8024Vit is a radial shaft seal built to hold lubricant in and keep dust, water and particles out. Its 30 mm shaft, 45 mm housing and 8.00 mm height put it in the range of gearboxes, pumps, electric motors and small to medium reducers. MR Industrial Accessories supplies this brand and can help you confirm the right seal for the job.

The designation 8024Vit identifies the seal itself. Read the three numbers before anything else: shaft 30 mm, housing 45 mm, height 8.00 mm. The Lz-R design means a sealing lip with a spring that rides on the shaft under lubrication. Those three dimensions are what you compare against the old part, since a mismatch in any of them will keep the seal from seating properly and can lead to a leak.

A seal in this size range shows up in gearboxes, centrifugal pumps, electric motors, compressors and transmission equipment. In each case the job is the same: keep oil or grease where it belongs and block contaminants from reaching the bearings. Because it is a wear part, plan to replace it whenever a leak shows up or whenever the equipment is opened for other work.

Before installing, confirm the shaft measures 30 mm and the housing 45 mm, with 8 mm of height available. The shaft surface should be clean and free of burrs or scoring. Lubricating the lip before pressing it in helps it slide into place. The Lz-R configuration is a lip with a spring running on the shaft, so if your original equipment uses a different lip arrangement, check with us first. Even pressure and correct alignment during installation are what keep the lip from being damaged.

If you are sourcing an equivalent, send the code 8024Vit or the three dimensions. We can also look at options in other brands or with a different lip design when the original does not suit the application. We work with brands and will guide you toward a part that does the job without requiring changes to the housing.