V-belt Dayco AP71
- Brand
- DAYCO
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical wrapped industrial belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DAYCO AP71 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AP71 and any equivalents.
The Dayco AP71 is a classical V-belt in A profile, built for standard industrial drives. It measures 1854.2 mm in length, with a 13 mm top width, 8 mm height and a 40 degree angle. Before you fit it, inspect the drive it runs on.
A new belt on a worn drive will not hold up. Check the sheave grooves for wear, scoring and buildup, and confirm the grooves match the A profile section. Misaligned sheaves and worn grooves are common causes of short belt life, noise and slip, and they are easier to correct before the belt goes on than after it fails.
Measure the old belt and read the marking on its back to confirm the part number and section. The AP71 is an A profile belt at 1854.2 mm, 13 mm top width, 8 mm height and 40 degrees. If the drive uses more than one belt, replace the full set at the same time so the load stays shared evenly across the grooves.
Send us the belt marking, the part number and the quantity you need, along with a photo of the drive if you have one. We carry Dayco belts and the team replies promptly by WhatsApp or email, and can help confirm the right belt or suggest an equivalent.
Dimensions
- Section
- A
- Length
- 1854.2mm
Frequently asked questions
- What are the dimensions of the Dayco AP71?
- It is an A profile classical V-belt with a length of 1854.2 mm, a top width of 13 mm, a height of 8 mm and a 40 degree angle.
- What should I check before installing this belt?
- Inspect the sheave grooves for wear, scoring and buildup, confirm the grooves match the A profile, and check shaft alignment. Correcting these before fitting the belt helps it run true and last.
- How do I request a quote for the AP71?
- Send the part number, the quantity and the belt marking by WhatsApp or email. A photo of the drive and the old belt helps us confirm the right belt or suggest an equivalent.