V-belt Dayco AP70

DAYCO AP70 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AP70 and any equivalents.

The Dayco AP70 is a classical wrapped V-belt in the A profile, built for industrial drives that use standard classical cross sections. It measures 1828.8 mm in length, with a 13 mm top width, 8 mm height and a 40° angle. MR Industrial Accessories supplies this belt to maintenance, engineering and purchasing teams across the US, Canada, Mexico and South America.

The most reliable way to match this belt is to read the marking on the back of the belt you are replacing. If it shows AP70, the Dayco AP70 is the direct match. If the old belt is worn or the marking is gone, measure the outside length and compare it to the 1828.8 mm figure, then check the cross section: an A profile belt is 13 mm across the top and 8 mm high, with a 40° angle.

Confirm the drive uses a classical A section before ordering. A wrapped classical belt like this one is used where the pulley groove is cut for the A profile and the drive runs at classical V-belt speeds. If the drive was converted to a narrow wedge section, the correct replacement will be a different profile even if the length is close.

When you request a quote, send the part number AP70, the quantity, and a photo of the belt marking if you have one. If the marking is unreadable, send the outside length and the top width so we can confirm the profile and length against the data for this belt.