V-belt Dayco AP26
- Brand
- DAYCO
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical wrapped industrial belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DAYCO AP26 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AP26 and any equivalents.
The Dayco AP26 is a classical V-belt in the A profile, with a length of 711.2 mm. Before you fit it, inspect the drive and sheaves, since worn grooves or misalignment will shorten the life of any new belt.
This belt has a top width of 13 mm, a height of 8 mm, and a 40° angle. It belongs to the Dayco classical wrapped industrial belts series. Confirm that your drive takes an A profile belt and that the old belt's marking matches 711.2 mm before ordering.
Check sheave grooves for wear, rust, and embedded debris, and verify that the sheaves are aligned and the shaft bearings turn freely. If the drive runs more than one belt, replace the full set so the load is shared evenly. Send the part number AP26 by WhatsApp or email for a quote.
When you request a quote, include the belt marking from the back of the old belt and the drive details so we can confirm the right belt or suggest an equivalent.
Dimensions
- Section
- A
- Length
- 711.2mm
Frequently asked questions
- What are the dimensions of the Dayco AP26?
- It is an A profile classical V-belt with a length of 711.2 mm, a top width of 13 mm, a height of 8 mm, and a 40° angle.
- How do I confirm this is the right belt for my drive?
- Read the marking on the back of the old belt and check that it matches the AP26 part number and the 711.2 mm length. Also confirm the drive uses an A profile.
- What should I inspect before fitting a new belt?
- Check the sheave grooves for wear and debris, verify sheave alignment, and make sure the bearings turn freely. On multi-belt drives, replace all belts in the set.