V-belt Dayco AP132
- Brand
- DAYCO
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical wrapped industrial belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DAYCO AP132 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AP132 and any equivalents.
The Dayco AP132 is a classical V-belt in the A profile, with a 13 mm top width, 8 mm height, 40 degree angle and a length of 3403.6 mm. It belongs to Dayco's line of classical wrapped industrial belts. This page gives you the data to match it against the belt you are replacing.
To confirm the AP132 is the right belt, start with the marking on the back of the old belt. Read the profile letter and the length, then compare them with the A profile and 3403.6 mm length listed here. Check the top width and height against the old belt as well: 13 mm across the top and 8 mm thick. The 40 degree angle is part of the profile, so a belt with the same A profile will match the sheave groove.
If the marking is worn off, measure the old belt. A classical V-belt is measured across the top and around the outside. A top width near 13 mm and a height near 8 mm point to the A profile. Measure the outside length to compare with 3403.6 mm. If the old belt is stretched or damaged, take the measurement before it is discarded.
Send the part number AP132, or the profile and length from the old belt, by WhatsApp or email. The team can confirm the belt and suggest an equivalent if needed. For a drive with more than one belt, order the full set so all belts on the drive are the same.
Dimensions
- Section
- A
- Length
- 3403.6mm
Frequently asked questions
- How do I match the Dayco AP132 to the belt I am replacing?
- Read the marking on the back of the old belt. The AP132 is an A profile classical V-belt with a 3403.6 mm length, 13 mm top width, 8 mm height and 40 degree angle. Compare those figures with the old belt or with its marking.
- What should I send to request a quote for the AP132?
- Send the part number AP132, or the profile and length from the old belt, by WhatsApp or email. If you are unsure of the profile, include the top width and height you measured.
- Should I replace all belts on the drive at the same time?
- On a drive that uses more than one belt, replace the full set so the belts are matched. Send the quantity you need with your quote request.