V-belt Stark SPZ 2000
- Brand
- STARK
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPZ
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
GATES and STARK: matching part numbers →OPTIBELT and STARK: matching part numbers →
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
STARK SPZ 2000 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPZ 2000 and any equivalents.
The Stark SPZ 2000 is a narrow wedge V-belt with an SPZ profile. Its top width is 9.7 mm, its height is 8 mm, and its included angle is 40 degrees. If you are replacing a worn belt, start by reading the marking on its back.
The marking on the back of the old belt is the most reliable starting point. Look for the profile and the length together, such as SPZ 2000. Confirm that the profile is SPZ and that the length matches 2000 mm. Also check the top width and height against 9.7 mm and 8 mm, and the angle against 40 degrees.
When you send a quote request, include the full marking from the back of the belt and the part number you need. If the marking is worn or unreadable, measure the top width and height and note the drive where the belt runs. The same size is also listed under Optibelt SPZ 2000, which you can mention if that is what you find.
For drives that use multiple belts, replace the full set at the same time so the belts share the load evenly. Inspect the sheaves for wear, alignment, and debris before installation, and check the belt tension after the drive has run under load.
Dimensions
- Section
- SPZ
Frequently asked questions
- How do I confirm this is the right belt?
- Read the marking on the back of the old belt. It should show SPZ 2000. You can also measure the top width and height and compare them to 9.7 mm and 8 mm. The included angle is 40 degrees.
- What should I send for a quote?
- Send the part number Stark SPZ 2000 or the full marking from the old belt. If the marking is not clear, send the profile, the length, and the top width and height you measured.
- Should I replace all belts on the drive at once?
- Yes. On a multi-belt drive, replace the full set so the belts work together. Also inspect the sheaves for wear and alignment before installing the new set.