SKF TMMK 10-30 mounting and maintenance tools

SKF TMMK 10-30 belongs to mounting and maintenance tools, part of our Mounting and maintenance tools range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for TMMK 10-30 and any equivalents.

The SKF TMMK kit pairs a jaw puller with a bearing mounting set in one tool. Maintenance teams use it to pull bearings off shafts and out of housings, and to seat them again without hammer blows or unnecessary heating. For a workshop that handles both jobs, it keeps the two operations under one part number. MR Industrial Accessories supplies this SKF tool line and quotes by part number through WhatsApp or email.

The part number tells you the working range, not the size of any single component. TMMK 10-30 covers one band of diameters, TMMK 10-35 a wider one, and TMMK 20-50 a larger one still. The two figures mark the ends of that band. Measure the shaft or housing diameter at the point where you will work, then match it against the range in the code. If your measurement falls outside the number you had in mind, send it to us and we will help you sort it out.

Typical users are industrial maintenance crews, mechanical shops, process plants, mining operations, food production and transport fleets. The work is the same everywhere: pumps, electric motors, gearboxes, fans and conveyors. The jaw puller takes off bearings that have seized without scoring the shaft, while the mounting set helps position the new bearing without impact. Both steps lower the chance of marking raceways or deforming components during the intervention.

Selection depends on the bearing type, the diameter and how much room you have at the mounting point. The puller needs enough clearance to rest its jaws on the raceway or ring being removed. The mounting set is matched to the bearing size and the type of fit. During mounting, check alignment and apply load evenly; if the bearing calls for heating, follow the recommended procedure. Lubrication and correct sealing finish the job.

TMMK kits work with bearings from different brands as long as the measurements fall inside the kit range. They are not a substitute for a hydraulic press when controlled force is required, but they cover most workshop tasks. If you already own a puller, the mounting set may be the piece you are missing. When you request a quote, include the complete part number and the working diameter so we can confirm the kit fits your job.

Send the part number to MR Industrial Accessories via WhatsApp or email and we will return your quote. We can also advise you if you are deciding between two working ranges, or if you only need the puller or only the mounting set.