SKF TMHP 10E hydraulic puller

SKF TMHP 10E belongs to hydraulic puller, part of our Mounting and maintenance tools range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for TMHP 10E and any equivalents.

The SKF TMHP 10E is a hydraulic jaw puller that uses a cylinder to generate the extraction force. It is built for removing bearings, bushings, gears and other parts that are press-fitted onto shafts, where a manual puller would not be sufficient. Maintenance teams in plants, workshops and repair shops use this type of tool to take components off without harming the shaft or the part itself.

In the SKF naming system, TMHP stands for a hydraulic jaw puller. The number that comes after the letters, 10 in this case, places the tool at a particular capacity level within the series. The trailing E denotes a configuration variant, which can involve the jaw style or the opening range. When reading a code like this, start with the size class, then check the variant letter against the job at hand.

These pullers show up in food processing, cement, petrochemical and steel operations, as well as in rail and automotive service shops. A typical job is pulling a bearing from a shaft after years of service, when rust or a tight interference fit makes the part hard to move. Hydraulic force lets the technician apply steady, controlled pressure instead of hammering on the component, which lowers the chance of damaging the shaft or the bearing.

Choosing the right unit comes down to three things: the pulling force needed, the jaw opening range and the grip depth. Because the force is hydraulic, it builds gradually and stays under control, so there is no need for impact blows that can deform parts. During setup, set the jaws on a solid, parallel surface; if they sit at an angle, they can slip and hurt the tool. Two routine steps, lubricating the thread and bleeding the cylinder, go a long way toward smooth and safe operation.

Crossing to a different brand is possible, but it is not a simple code-for-code swap. Pulling force, reach and jaw type all have to line up, and manufacturers do not follow a common numbering system. The practical approach is to compare the technical data side by side. If you send us the code you are using now, we can point you to the SKF model that fits the same application.

To get a quote for the SKF TMHP 10E or another puller in the line, send the part number on WhatsApp or by email. The MR team can also suggest equivalents and help you confirm the right choice for your job. We work with workshops, plants and maintenance services across the United States and in several Latin American countries.