V-belt Optibelt XPA 1207 XEP
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- XPA
- Series
- Super XE-Power Pro M=S
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT XPA 1207 XEP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for XPA 1207 XEP and any equivalents.
This Optibelt XPA 1207 XEP is a cogged narrow V-belt from the Super XE-Power Pro M=S series. The XPA profile sets the cross-section that must match your pulley groove, and the 1207 mm length sets the belt's outside dimension around the drive. Both values are printed on the belt so you can compare them directly with what is on the machine.
Profile and length are the two figures that decide whether a belt fits. XPA is a narrow wedge cross-section, and 1207 mm is the length for this part number. If your existing belt is marked XPA with the same 1207 mm length, this is the size to quote. If the marking has worn off, measure the old belt and read the drive pulleys before ordering.
Cogged narrow V-belts are used where a standard wrapped belt runs hot or slips on small-diameter pulleys. The molded cogs let the belt flex around tight bends. Send us the part number XPA 1207 XEP, or the profile and length off the back of the old belt, and we will confirm the match.
When a drive runs more than one belt, replace the full set at the same time so the load stays even across the grooves. Check pulley wear and alignment while the belts are off.
Dimensions
- Section
- XPA
- Length
- 1207mm
Frequently asked questions
- What do the XPA and 1207 in this part number tell me?
- XPA is the profile, the narrow wedge cross-section that has to match the pulley groove. 1207 mm is the length of this belt. Both are listed on the product page and are normally printed on the back of the belt.
- How do I confirm this is the belt on my drive?
- Read the marking on the old belt. If it shows XPA and the same length, this part number is the size to quote. If the marking is gone, measure the old belt and note the pulley dimensions, then send those details to our team.
- What should I send to get a quote?
- Send the part number XPA 1207 XEP, or the profile and length from the old belt, by WhatsApp or email. Our team will confirm the belt or suggest an equivalent.