V-belt Optibelt XPA 1180 XEP
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- XPA
- Series
- Super XE-Power Pro M=S
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT XPA 1180 XEP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for XPA 1180 XEP and any equivalents.
This page covers the Optibelt XPA 1180 XEP, a cogged narrow V-belt from the Super XE-Power Pro M=S series. The two figures that matter when you select it are the profile and the length. The XPA profile sets the cross-section that must match the pulley groove, and 1180 mm sets the datum length.
Start by reading the marking on the back of the belt you are replacing. If it shows XPA and 1180 mm, this Optibelt belt matches those two values. A belt with the same length but a different profile will not sit correctly in the groove, and a belt with the same profile but a different length will not tension properly. Both values need to line up before you order.
Cogged narrow V-belts are used where a compact cross-section is needed to transmit load through small pulley diameters. On a worn drive, check the pulley grooves for wear and the sheaves for alignment before fitting a new belt. If the drive runs more than one belt, replace the full set at the same time so the load stays evenly divided.
To request a quote, send the part number XPA 1180 XEP by WhatsApp or email. If you are unsure whether this is the correct belt for your drive, include a photo of the marking on the old belt and we can help confirm the profile and length or suggest an equivalent.
Dimensions
- Section
- XPA
- Length
- 1180mm
Frequently asked questions
- What do the XPA profile and 1180 mm length mean?
- XPA is the profile of this cogged narrow V-belt, which determines the cross-section that fits the pulley groove. 1180 mm is the length. Both values must match the drive for the belt to seat and tension correctly.
- How do I confirm this is the right belt before ordering?
- Read the marking on the back of the belt you are replacing. If it shows XPA and 1180 mm, this Optibelt belt matches. If you are unsure, send a photo of the old belt marking with your quote request and we can help confirm it.
- Should I replace all the belts on the drive at once?
- If the drive runs more than one belt, replace the full set together. Mixing a new belt with worn belts on the same drive can cause uneven load sharing and uneven wear.