V-belt Optibelt X22 x 2598

OPTIBELT X22 x 2598 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for X22 x 2598 and any equivalents.

This Optibelt Super TX M=S belt is a cogged classical V-belt in the CX profile, with a length of 2598 mm. It is the type of belt used on drives where a raw-edge cogged construction is called for, and where the sheave groove is cut to accept a CX cross-section. Confirm the profile and the length against your drive before ordering.

Cogged classical V-belts are common on industrial drives that run over small-diameter pulleys, where the molded cogs help the belt bend through the arc. They also suit drives that operate in environments where heat buildup at the belt back is a concern, and on equipment where some slip under shock loads is tolerated by the drive design. The CX profile here is the classical cross-section, not a narrow wedge belt, so the pulley grooves must be cut to match.

To confirm fit, read the marking on the back of the belt you are replacing. Check that the profile and the length match the CX and 2598 mm given for this belt, and inspect the sheaves for wear, grooves that have widened, or a polished bottom where the belt has been riding. A worn sheave can make a correct belt sit low and slip, so measure the groove if the drive has been in service for a long time.

If the marking is worn off, measure the outside length of the old belt and note the cross-section, then send both with the drive details. We can compare that against this Optibelt X22 x 2598 and help you confirm the right belt or suggest an equivalent.