V-belt Optibelt SPZ 887

OPTIBELT SPZ 887 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPZ 887 and any equivalents.

This Optibelt SPZ 887 belt is a narrow wedge V-belt from the SK metric profile line. It has an SPZ profile, an 887 mm length, a 9.7 mm top width, an 8 mm height, and a 40-degree angle. To match it to the belt being replaced, read the marking on the old belt and confirm the profile and length.

The SPZ profile and 887 mm length are the two key figures. The SPZ profile is a narrow wedge section, and the 887 mm length is the datum length for this belt. The top width is 9.7 mm, the height is 8 mm, and the angle is 40 degrees. When you have the old belt in hand, check that its marking shows the same profile and length. If the old belt is worn or the marking is unreadable, measure the outside length and compare it to the 887 mm figure, but keep in mind that length conventions can vary between belt types.

A narrow wedge V-belt like this one is typically used in drives where space is limited and speeds are higher than with classical V-belts. Inspect the pulleys for wear, alignment, and debris before installing a replacement. Check that the belt sits correctly in the groove and that the drive is tensioned according to the equipment manual. If the drive uses multiple belts, replace them as a set so the load is shared evenly.

To request a quote, send the part number SPZ 887, the quantity, and any details from the old belt marking. If you are unsure whether this is the correct belt, send a photo of the old belt and the pulley grooves. The team can help confirm the right belt or suggest an equivalent.