V-belt Optibelt SPC KB 6700 RP

OPTIBELT SPC KB 6700 RP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPC KB 6700 RP and any equivalents.

This Optibelt SPC KB 6700 RP belt is a banded V-belt from the KB Red Power 3 series, with a length of 6700 mm. Banded V-belts are used on drives with multiple parallel grooves where the ribs must run as one unit, keeping the belt from turning over or whipping. If you are replacing a belt on a high-load industrial drive, confirm the profile and length before you order.

To confirm fit, read the marking on the back of the old belt and compare it with the part number SPC KB 6700 RP. The profile and the 6700 mm length are the two dimensions to match. Check the pulley grooves for wear and make sure the belt sits at the correct height in the groove.

Banded V-belts are common on drives where a single belt would not carry the load or where pulsating loads cause vibration. Inspect the whole set: if one rib is worn or stretched, the banded belt should be replaced as a unit. Also check sheave alignment and tension, since misalignment is a frequent cause of banded belt failure.

When you request a quote, send the part number SPC KB 6700 RP and the quantity you need. If you are unsure about the profile or length, include a photo of the belt marking and the pulley arrangement. We carry Optibelt belts and can help confirm the right belt or suggest an equivalent.