V-belt Optibelt BCP 675
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- Conveyor Power
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT BCP 675 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for BCP 675 and any equivalents.
This Optibelt BCP 675 belt is a classical V-belt from the Conveyor Power series, built for the long-center drives found on conveying equipment. It has a B profile and a length of 17221 mm. If you are replacing a worn belt on a conveyor drive, this page gives you the dimensions to confirm before you order.
The B profile sits at 17 mm across the top and 11 mm high, with a 40-degree angle. Those three figures, together with the 17221 mm length, are what you match against the old belt or the drive specification. A classical V-belt of this size is typically used where the drive centers are long and the belt runs over standard B-section pulleys.
To confirm fit, read the marking on the back of the belt you are removing and compare it with BCP 675. Check the pulley groove width against the 17 mm top width, and measure the outside length if the marking is worn away. If the old belt has stretched or the drive has been modified, send the pulley diameters and center distance with your request so we can help you verify the length.
Belts on conveying drives often run in sets or on multiple-groove pulleys. If more than one belt drives the same shaft, replace them together and keep the matched length so the load stays even across the grooves. Inspect the pulleys for wear or debris at the same time, since a groove that no longer matches the 40-degree angle will shorten the life of any new belt.
Dimensions
- Section
- B
- Length
- 17221mm
Frequently asked questions
- How do I confirm that the BCP 675 is the right belt for my drive?
- Compare the marking on your old belt with BCP 675. Then check the profile dimensions: B section, 17 mm top width, 11 mm height, 40-degree angle, and 17221 mm length. If the marking is unreadable, measure the old belt and the pulley grooves.
- What information should I send with my quote request?
- Send the part number BCP 675 and, if you have it, the marking from the old belt. Pulley diameters, the number of grooves and the center distance between shafts help us confirm the length and profile before you order.
- Can I replace just one belt on a multi-belt drive?
- On a drive that uses more than one belt, it is standard practice to replace the full set at the same time. Mixing a new belt with worn ones can leave the load uneven across the grooves. Use belts of the same length and profile.