Timing belt Optibelt 5M 120 (HTD)
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Omega
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 5M 120 (HTD) belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5M 120 (HTD) and any equivalents.
This Optibelt Omega timing belt uses the HTD 5M profile with a 120 mm length and 5 mm pitch. It is a synchronous belt for drives where the belt teeth mesh with pulley grooves to keep motion in step. Use the marking and measurements to confirm it matches your drive before ordering.
HTD profile timing belts are common on compact drives that need positive synchronization rather than friction. The rounded tooth form of the HTD 5M profile suits small pulleys and light-duty indexing, positioning or transmission tasks. Confirm the belt by reading the back marking and checking that the profile and length match the original belt.
To verify fit, compare the profile and the 120 mm length against the belt you are replacing. Check the pulley grooves for wear and make sure the belt sits correctly in the grooves without riding high. If the drive uses more than one belt, replace the full set at the same time so the load stays even.
When you request a quote, send the part number 5M 120 (HTD) and the belt marking. If you are unsure of the correct belt, include the profile and length from the old belt and the pulley details. The team can confirm the belt or suggest an equivalent.
Dimensions
- Profile
- HTD 5M
- Pitch
- 5mm
- Length
- 120mm
Frequently asked questions
- How do I confirm this timing belt fits my drive?
- Check the belt marking and compare the profile and length to the belt you are replacing. This belt is HTD 5M profile with a 120 mm length and 5 mm pitch. Also inspect the pulleys for wear or damage.
- What should I send to get a quote?
- Send the part number 5M 120 (HTD) and the marking from the back of the belt. If you do not have the part number, provide the profile and length from the old belt and any pulley details you have.
- Can I replace just one belt on a multi-belt drive?
- On drives that use more than one belt, replace the full set at the same time. Mixing a new belt with used belts can cause uneven load and premature wear.