Timing belt Optibelt 50 / 5M 11200 AFX
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Alpha Flex
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 50 / 5M 11200 AFX belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 50 / 5M 11200 AFX and any equivalents.
This Optibelt Alpha Flex belt is a timing belt with an HTD 5M profile and a 11200 mm length. It is used in drives where synchronous power transmission is required and the pulley grooves match the HTD 5M profile. Confirm fit by checking the existing belt marking and the drive's pulley profile.
The 50 / 5M 11200 AFX is built for drives that need exact rotational synchronization between shafts. The HTD 5M profile and 11200 mm length must match the pulleys and the required center distance. This belt is not a substitute for a different profile or length; using the wrong size can cause poor engagement or premature wear.
To confirm fit, read the marking on the back of the old belt and compare it to the part number, profile and length shown here. Also inspect the pulleys for wear and check that the drive's take-up range can accommodate the belt. If the marking is unreadable, measure the old belt's length and count the pulley grooves to identify the profile.
When replacing a timing belt, inspect the entire drive: pulley teeth, flanges, tensioner bearings and shaft alignment. On multi-belt drives, replace all belts in the set to keep loads even. For a quote, send the part number 50 / 5M 11200 AFX, the quantity and any details from the old belt marking.
Dimensions
- Profile
- HTD 5M
- Pitch
- 5mm
- Length
- 11200mm
Frequently asked questions
- How do I confirm this timing belt fits my drive?
- Check that the pulley grooves are HTD 5M and that the required belt length is 11200 mm. Compare these to the marking on the old belt and the drive's specifications.
- Can I use this belt if the old marking is worn off?
- Yes, but you must identify the profile and length by measuring the old belt and the pulleys. The profile must be HTD 5M and the length 11200 mm.
- What information do you need for a quote?
- Send the part number 50 / 5M 11200 AFX, the quantity required and any details from the old belt or drive. We will confirm the belt and reply promptly.