Timing belt Optibelt 25 AT10 / 3200 AFX
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Alpha Flex
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 25 AT10 / 3200 AFX belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 25 AT10 / 3200 AFX and any equivalents.
The Optibelt 25 AT10 / 3200 AFX is an Alpha Flex timing belt built on the AT10 profile with a 3200 mm length and a 10 mm pitch. The profile sets the tooth geometry that must match your pulleys; the length sets where the belt sits in the drive layout. Read both against the belt you are replacing before you order.
Profile and length are the two figures that decide whether a timing belt fits. AT10 describes the tooth form that engages the pulley grooves, and the 10 mm pitch is the center-to-center distance between adjacent teeth. The 3200 mm length is the datum for the run around the pulleys and any idler or tensioner in the path.
A practical check is to read the marking on the back of the belt you are removing. If it shows the same AT10 profile and the same 3200 mm length, the Optibelt 25 AT10 / 3200 AFX is the direct match. Where the marking is worn or unreadable, measure the length along the belt and count teeth over a known span to confirm the pitch.
For a quote, send the part number 25 AT10 / 3200 AFX, the quantity, and a photo of the back marking or the old belt. If the profile or length you find differs, send those figures as well and we will help confirm the right belt or suggest an equivalent.
Dimensions
- Profile
- AT10
- Pitch
- 10mm
- Length
- 3200mm
Frequently asked questions
- What do the profile and length tell me about this belt?
- The AT10 profile defines the tooth form that must match your pulley grooves, and the 10 mm pitch is the spacing between teeth. The 3200 mm length is the measurement around the belt path, so both figures need to agree with your drive.
- How do I confirm this is the belt I need?
- Check the marking on the back of the belt you are replacing. If it reads AT10 and 3200 mm, this belt matches. If the marking is not legible, measure the length and confirm the pitch against the pulleys.
- What should I send to request a quote?
- Send the part number 25 AT10 / 3200 AFX and the quantity you need by WhatsApp or email. A photo of the old belt or its back marking helps us confirm the profile and length before we reply.