V-belt Optibelt 17 X 11500 CP
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- Conveyor Power
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 17 X 11500 CP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 17 X 11500 CP and any equivalents.
The Optibelt 17 X 11500 CP is a classical V-belt from the Conveyor Power series, supplied by MR Industrial Accessories. With a profile B cross-section, a 17 mm top width, an 11 mm height and a 40 degree angle, it is built for long-center drives where the belt runs over large sheaves. Before fitting it, inspect the drive and sheaves so the new belt starts on a sound system.
Check sheave grooves for wear, corrosion, burrs and embedded debris. A worn groove lets the belt sit too deep, so it slips and wears fast even when the belt itself is correct. Confirm the sheaves are aligned and the shafts turn freely, then measure the center distance and compare it with the 11500 mm length before the belt goes on.
Look at the whole drive, not just the belt. Worn bearings, a loose mounting base or a driven load that has changed can shorten belt life. If the old belt failed early, correct the cause first. When a drive uses more than one belt, fit the full set together so the load is shared evenly.
To quote the Optibelt 17 X 11500 CP, send the part number, the quantity and the drive details by WhatsApp or email. Our team can confirm the profile and length, and help you identify the right belt for the application.
Dimensions
- Section
- B
- Length
- 11500mm
Frequently asked questions
- What are the dimensions of the Optibelt 17 X 11500 CP?
- It is a profile B classical V-belt with a 17 mm top width, an 11 mm height, a 40 degree angle and a length of 11500 mm.
- Should I check the sheaves before installing this belt?
- Yes. Inspect the sheave grooves for wear and damage, check alignment and make sure the shafts turn freely. Correcting drive problems before fitting the belt helps it run as intended.
- How do I request a quote for the Optibelt 17 X 11500 CP?
- Send the part number, the quantity you need and any drive details by WhatsApp or email. Our team replies promptly and can confirm the belt for your application.