V-belt Optibelt 10 x 1050 Li
- Brand
- OPTIBELT
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- Z
- Series
- VB S=C Plus
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
OPTIBELT 10 x 1050 Li belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 10 x 1050 Li and any equivalents.
This Optibelt VB S=C Plus belt is a classical V-belt with a Z profile and a 1050 mm length. It is the type of belt used on low-power industrial drives such as fans, pumps, small conveyors and light machine tools, where a single belt runs in a standard Z-section pulley groove.
Classical V-belts in the Z profile are common on fractional-horsepower drives and on equipment that has been in service for years. The belt is identified by the marking on its back, which in this case reads 10 x 1050 Li, so the easiest way to confirm you are ordering the same item is to read that marking off the belt currently on the drive.
If the old belt is worn or the marking is no longer legible, measure the outside length of the belt and check the pulley groove width against the Z profile. Confirm the number of belts on the drive as well; where a drive runs more than one belt, replacing the full set at once keeps tension even across the grooves.
Send the part number 10 x 1050 Li, or a photo of the belt marking, by WhatsApp or email and the team will confirm the right belt for your drive. If the exact belt is not what you need, the same size and profile information helps identify a suitable match.
Dimensions
- Section
- Z
- Length
- 1050mm
Frequently asked questions
- How do I confirm this is the right belt for my drive?
- Read the marking on the back of the belt you are replacing. If it shows 10 x 1050 Li, that identifies the profile and length. You can also measure the outside length and check that the pulley grooves take a Z profile.
- What is this belt used for?
- Classical V-belts in this profile are used on low-power industrial drives such as fans, pumps, small conveyors and light machine tools running in standard Z-section pulleys.
- Can I order just one belt, or should I replace the set?
- On a single-belt drive, one belt is enough. On a drive running two or more belts in matched grooves, replacing the whole set at the same time keeps tension even and avoids uneven wear.