Industrial pulley 360 mm, 2 grooves, section C

EMMAR POLEA 360 2C belongs to pulleys, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for POLEA 360 2C and any equivalents.

The EMMAR 360 2C is a V-belt pulley built for section C belts. It measures 360 mm in diameter and carries two grooves. This configuration suits drives that need to move torque from a motor to a machine shaft at a set ratio. Because EMMAR produces these pulleys in its own shop, the groove cutting and balancing steps stay under direct control, which helps the belt track straight and wear evenly.

The code POLEA 360 2C tells you the essentials: 360 mm diameter, 2 grooves, section C. Section C refers to wide-profile V-belts, a category chosen for higher power at moderate speed. Two grooves let you run two belts side by side on the same pulley. Use this pulley where the belt section, diameter and groove count match your drive design.

You will find pulleys like this on grinders, mixers, compressors, process pumps and lifting gear, as well as in line-shaft setups where the motor and driven shaft sit apart and belts handle the speed change. Maintenance teams often keep one on hand as a replacement when a pulley wears out or when a ratio change is planned.

When selecting, start with the belt: it must be section C. Then confirm the pitch diameter your drive calls for and the number of grooves, since those two decide how much power the pulley can carry. At installation, line the pulley up with its counterpart, keep runout low, and tension the belt to the belt maker's specification. Even slight misalignment will scuff the belt sidewalls and set up vibration.

If you need a match, send the part number POLEA 360 2C through WhatsApp or email, along with the section, diameter and groove count you are after. Our team reviews the in-house manufacturing line and comes back with the closest option for your machine.

EMMAR also makes other pulleys in the power transmission range. If your equipment calls for a different diameter or a different number of grooves, ask us; custom manufacturing can be assessed. Forward the part number or a photo of the old pulley by WhatsApp and we will respond with the available choice.