Double sprocket with hub, pitch 1/2", 10 teeth

MR Piñón doble 1/2" Z10 belongs to sprockets and gears, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for Piñón doble 1/2" Z10 and any equivalents.

When one shaft has to run two chain lines at the same speed, a double sprocket with a single hub is often the simplest answer. This one carries two toothed rings on a common body, cut in SAE 1045 steel, with a 1/2" pitch and 10 teeth. The 1/2" pitch puts it in the ANSI 40 roller chain range, and the 10-tooth count makes it a small, fast-turning sprocket suited to light-duty drives.

The part is a double sprocket with hub, 1/2" pitch, 10 teeth (z=10), machined from SAE 1045 steel. In the designation Double sprocket 1/2" Z10, the double refers to the two toothed rings formed on the same body, and the hub is the central section that mounts on the shaft. Because the pitch is 1/2", ANSI 40 roller chain is the matching chain family. Ten teeth is a low count, so the sprocket turns relatively fast for its diameter. The hub can be secured with a key, a set screw, or both, depending on how the equipment is built.

Drives that need two chain strands moving together are the usual home for this pitch: roller conveyors, small bucket elevators, packaging machines, screw feeders and hand-driven mechanisms. It also turns up as the output sprocket in simple reducers and in gate opening and closing systems. SAE 1045 steel gives it good resistance to wear in continuous duty, provided lubrication is kept up.

Selection starts with the chain: confirm the pitch is 1/2" and that the tooth count gives the ratio you want. Then check the shaft diameter and how the hub will be fixed, whether by keyway, set screw or both. At assembly, line up each toothed ring with its own chain, set the tension, and lubricate with an oil or grease made for roller chain. A small sprocket like the Z10 wears quickly, so inspect the teeth often.

Need a single sprocket instead of a double, or another pitch? Send the part number MR-PINON-DOBLE-1-2-Z10 or the full designation by WhatsApp. With the pitch, tooth count and shaft diameter we can point you to the equivalent variant or source it to your measurements. MR Industrial Accessories LLC also manufactures split plummer block housings, roller chains and sheaves, so we can help with the rest of the drive.

For a quote on this double sprocket 1/2" Z10, message us on WhatsApp with the part number and the quantity. If you are unsure about chain compatibility or shaft mounting, send a photo or the equipment drawing and we will look it over. Power transmission is our line of work, and we would rather sort out the details before the part goes into service.