V-belt Movendis PP-SPZ1337
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPZ
- Series
- PowerPlus Narrow Wedge V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-SPZ1337 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-SPZ1337 and any equivalents.
The Movendis PP-SPZ1337 is a PowerPlus narrow wedge V-belt with an SPZ profile and a 1337 mm length. It is built to the 40-degree angle, with a 9.7 mm top width and 8 mm height. Use these four dimensions to match it to the belt you are replacing.
Start with the belt you are removing. Read the marking on the back: it should show the profile and the length. If it reads SPZ 1337, this belt matches on profile and length. Also check the top width and height against 9.7 mm and 8 mm, and confirm the 40-degree angle is correct for your sheave grooves. A belt that is close in length but different in profile will not sit correctly in the groove.
Narrow wedge V-belts like this SPZ profile carry higher power in a smaller cross-section than classic V-belts, so a wrong profile can change how the drive runs. Inspect the sheaves while the belt is off: look for worn grooves, debris, and any sharp edges that could damage a new belt. If the drive uses more than one belt, replace them as a set so the load stays even across all belts.
When you request a quote, send the part number PP-SPZ1337 and the quantity. If you are not certain the marking matches, send a photo of the belt back and the sheave dimensions, and the team can help confirm the right belt or suggest an equivalent.
Dimensions
- Section
- SPZ
- Length
- 1337mm
Frequently asked questions
- What do I need to check to match this belt to the one being replaced?
- Confirm the profile SPZ, the length 1337 mm, the top width 9.7 mm, the height 8 mm, and the 40-degree angle. The marking on the back of the old belt is the fastest starting point.
- What should I send to get a quote for this belt?
- Send the part number PP-SPZ1337 and the quantity you need. If you are unsure about the match, include a photo of the belt marking and the sheave dimensions.
- Should I replace more than one belt at a time?
- If the drive uses multiple belts, replace them as a set. Mixing a new belt with worn belts can cause uneven load across the drive.