V-belt Movendis PP-CX23-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- CX
- Series
- PowerPlus EPDM Cogged Raw Edge Classical
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-CX23-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-CX23-EPDM-AS and any equivalents.
The Movendis PP-CX23-EPDM-AS is a cogged classical V-belt with a CX profile and a 640 mm length, part of the PowerPlus EPDM Cogged Raw Edge Classical series. Cogged classical belts are commonly used on industrial drives where a standard wrapped belt would run hot or slip, such as fans, pumps, compressors and light-duty conveyors. Confirm fit by matching the CX profile and the 640 mm length to the belt you are replacing.
The raw edge and cogged construction help the belt flex around smaller pulleys and dissipate heat, which suits drives that see frequent starts or continuous duty. The EPDM compound is intended for outdoor and high-temperature environments, so it is a practical choice for equipment that runs in less controlled conditions.
To confirm the replacement, read the marking on the back of the old belt. You need the profile, CX, and the length, 640 mm. If the old belt is worn or the marking is unreadable, measure the outside length and compare it to the 640 mm figure, and check the pulley groove width to verify the CX profile.
When you request a quote, send the part number PP-CX23-EPDM-AS, the quantity, and the equipment it goes on. If you are replacing a set, include the number of belts on the drive so we can quote the full set.
Dimensions
- Section
- CX
- Length
- 640mm
Frequently asked questions
- What does the CX profile mean for my drive?
- CX is a classical V-belt profile. The belt is designed to sit in a matching CX pulley groove. Check the old belt marking or the pulley groove width to confirm it is CX before ordering.
- How do I confirm the 640 mm length is correct?
- Compare the 640 mm length to the marking on your old belt. If the marking is gone, measure the old belt and match it to 640 mm. The profile and length together identify the belt.
- Can I use this belt on a drive that originally used a wrapped belt?
- Yes, if the profile and length match. A cogged raw edge belt like this one is often used where a wrapped belt runs hot or slips. Confirm the pulley groove is compatible with a CX profile.