V-belt Movendis PP-BX39-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- BX
- Series
- PowerPlus EPDM Cogged Raw Edge Classical
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-BX39-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-BX39-EPDM-AS and any equivalents.
This Movendis PowerPlus EPDM Cogged Raw Edge Classical belt is a cogged classical V-belt in the BX profile, with a length of 1033 mm. Cogged raw edge classical belts are commonly used on industrial drives where space is tight and small pulley diameters are involved. Confirm fit by profile and length before ordering.
The cogged raw edge construction is intended for drives that run over smaller pulleys, where a standard wrapped belt may not flex as easily. The BX profile and 1033 mm length are the two dimensions to match against your existing belt or drive specification.
To confirm fit, read the marking on the back of the old belt. The profile should read BX, and the length should correspond to 1033 mm. If the old belt is worn or the marking is unreadable, measure the outside length and compare it to the 1033 mm figure, or send a photo of the belt and the drive sheaves.
This belt is supplied as a single unit. On drives that use multiple belts, replace the full set at the same time so the load is shared evenly. Inspect sheave grooves for wear and check pulley alignment before installing the new belt.
Dimensions
- Section
- BX
- Length
- 1033mm
Frequently asked questions
- How do I confirm this belt fits my drive?
- Check the profile and length against your existing belt or drive specification. The profile is BX and the length is 1033 mm. If you are unsure, send the part number or a photo of the old belt.
- Can I replace just one belt on a multi-belt drive?
- It is best practice to replace all belts on the drive at the same time. Mixing a new belt with worn belts can cause uneven load sharing and premature wear.
- What information do I need to request a quote?
- Send the part number PP-BX39-EPDM-AS, the quantity, and any drive details you have. If you are matching an existing belt, include the profile and length from the old belt marking.