V-belt Movendis PP-AX125-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- AX
- Series
- PowerPlus EPDM Cogged Raw Edge Classical
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-AX125-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-AX125-EPDM-AS and any equivalents.
The Movendis PP-AX125-EPDM-AS is a cogged classical V-belt in the AX profile, 3212 mm long. It is built for drives that need a classical cross-section with the flexibility of a raw-edge cogged construction. Use it where a standard wrapped belt runs hot or slips under shock loads.
Cogged classical V-belts are common on industrial fans, pumps, compressors, and process equipment that start and stop often or run at higher speeds. The cogs on the underside improve flexibility and heat dissipation compared with a plain wrapped belt. This belt uses an EPDM compound, which resists hardening and cracking in hot or damp plant environments.
To confirm fit, read the marking on the back of the old belt. You need the profile (AX) and the length (3212 mm). Check the pulley groove width and the belt's top width against the AX profile, and confirm the center distance and pulley diameters match the 3212 mm length. If the old belt is worn, measure the drive with a tape or use the pulley pitch diameters to verify the length before ordering.
Send the part number PP-AX125-EPDM-AS, or the profile and length from your old belt, by WhatsApp or email. Our team will confirm the belt or suggest an equivalent if the exact number is not what you need.
Dimensions
- Section
- AX
- Length
- 3212mm
Frequently asked questions
- What does the AX profile mean for fit?
- AX is a classical V-belt profile. Match it to the pulley groove; the belt's top width and height must sit correctly in the sheave. If the old belt is an AX, this belt is the same profile.
- How do I confirm the 3212 mm length?
- Read the number on the back of the old belt. If it is worn, measure the drive: with two pulleys, use the pulley diameters and center distance to calculate the belt length, or use a belt measuring tape around the pulleys. The length must match 3212 mm.
- Can I use this belt on a drive that currently runs a wrapped belt?
- Yes, if the profile and length match. A cogged raw-edge belt like this one can replace a wrapped belt of the same profile and length, and it may run cooler and flex easier on small pulleys. Check pulley condition and alignment before installing.