V-belt Movendis PP-AX100-EPDM-AS

MOVENDIS PP-AX100-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-AX100-EPDM-AS and any equivalents.

The Movendis PP-AX100-EPDM-AS is a cogged classical V-belt in the AX profile with a length of 2577 mm. It is part of the PowerPlus EPDM Cogged Raw Edge Classical series. This belt is used on industrial drives where a classical cross-section is required and the pulley grooves accept an AX profile.

Cogged classical V-belts like this one are common on drives that run at higher speeds or over smaller pulleys, where the raw edge and molded cogs help the belt bend without losing grip. Typical equipment includes fans, pumps, compressors, and other general industrial machinery. Because the profile is AX and the length is 2577 mm, the belt will only fit drives designed for that cross-section and center distance.

To confirm fit, check the marking on the old belt. If it shows AX and a length close to 2577 mm, this Movendis belt is the correct profile and size. Also inspect the pulley grooves for wear or debris and make sure the drive is aligned. If the old belt is not marked, measure the outside length and compare it to 2577 mm, or send a photo of the belt and pulleys with your quote request.

When replacing a belt on a multi-belt drive, install a full set of belts from the same production run so they share the load evenly. Check the tension after the first few hours of operation and again after a week. The EPDM construction of this belt is designed for industrial service, but it should be stored away from direct sunlight and extreme heat before installation.