V-belt Movendis PP-3VX960-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- 3VX
- Series
- PowerPlus EPDM Cogged Raw Edge Narrow
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-3VX960-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-3VX960-EPDM-AS and any equivalents.
The Movendis PP-3VX960-EPDM-AS is a cogged narrow V-belt in the 3VX profile with a length of 2438 mm. Before fitting it, inspect the drive and sheaves so the new belt seats and runs correctly from the start.
Check sheave grooves for wear, rust, burrs or embedded debris. Worn or damaged grooves can prevent a new cogged narrow V-belt from seating properly, which leads to slipping, heat and short belt life. Confirm the sheaves are aligned and the grooves match the 3VX profile. Turn the drive by hand and look for rough or tight spots in the bearings.
Verify the old belt marking against the replacement. The Movendis PP-3VX960-EPDM-AS carries a 3VX profile and a 2438 mm length. If the drive uses multiple belts, replace them as a set so the load is shared evenly. Keep the old belt for comparison and note its condition to help identify the cause of any failure.
When you request a quote, send the part number PP-3VX960-EPDM-AS, the quantity and any details from the old belt marking. If the number is not readable, share the profile, the length and photos of the drive and sheaves. We carry Movendis belts and can help confirm the right belt or suggest an equivalent.
Dimensions
- Section
- 3VX
- Length
- 2438mm
Frequently asked questions
- How do I confirm this belt fits my drive?
- Compare the marking on the old belt with the 3VX profile and 2438 mm length of the Movendis PP-3VX960-EPDM-AS. If the marking is worn off, measure the drive and send photos of the sheaves and setup.
- What should I check on the sheaves before fitting a new belt?
- Inspect the grooves for wear, rust, burrs or debris, confirm the sheaves are aligned and make sure the grooves match the 3VX profile. Turn the drive by hand to check for rough or tight bearings.
- What information do you need to quote this belt?
- Send the part number PP-3VX960-EPDM-AS and the quantity you need. If you are replacing an unmarked belt, include the profile, the length and photos of the drive and sheaves so we can help confirm the right belt.