V-belt Movendis P-SPZ1880
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPZ
- Series
- Narrow Wedge V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-SPZ1880 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-SPZ1880 and any equivalents.
When the marking on an old narrow wedge V-belt is worn or unreadable, the drive still has to be identified correctly. This page covers the Movendis P-SPZ1880, a narrow wedge V-belt with an SPZ profile and a length of 1880 mm. Use the figures below to compare against the belt you are replacing.
The P-SPZ1880 is built to the SPZ profile: 9.7 mm top width, 8 mm height and a 40 degree angle. Its length is 1880 mm. These are the values to check first, because a belt that matches the profile but not the length will not sit correctly in the pulley grooves or hold the right tension.
If the back of the belt is too worn to read, look for any remaining characters and note the profile and length from the drive documentation or the pulley dimensions. Send the part number, the profile and the 1880 mm length to our team by WhatsApp or email, and we will confirm the belt or suggest an equivalent.
Replacing a narrow wedge V-belt is also a good moment to inspect the pulleys for wear, check alignment and confirm the tension is set to the drive maker's specification. On multi-belt drives, fit the full set at the same time so the load is shared evenly.
Dimensions
- Section
- SPZ
- Length
- 1880mm
Frequently asked questions
- What are the dimensions of the Movendis P-SPZ1880?
- It is an SPZ profile narrow wedge V-belt with a length of 1880 mm, a top width of 9.7 mm, a height of 8 mm and a 40 degree angle.
- How do I identify this belt if the marking is worn off?
- Check the drive documentation or measure the pulley grooves to confirm the SPZ profile, then verify the 1880 mm length. Send those details to our team and we will help confirm the correct belt.
- Should I replace all belts on the drive at once?
- On drives that use more than one belt, replacing the full set together helps keep tension and load sharing even across the belts.