V-belt Movendis P-SPB2580
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPB
- Series
- Narrow Wedge V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-SPB2580 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-SPB2580 and any equivalents.
The Movendis P-SPB2580 is a narrow wedge V-belt in the SPB profile, 2580 mm long, with a 16.3 mm top width, 13 mm height and a 40-degree angle. Before you fit a replacement, inspect the drive so the new belt is not damaged by worn components.
Check the sheave grooves for wear, rust, oil or built-up debris. A groove that has worn wider lets the belt sit too deep, so it slips and wears fast even when the belt itself is correct. Look at both sheaves on the drive, not only the one that is easiest to reach.
Check alignment between the sheaves and confirm the shafts and bearings turn freely. Misalignment and a rough bearing both shorten belt life, and the same faults will shorten the life of the P-SPB2580. Tension the belt to the drive manufacturer's specification for the SPB profile.
If you are replacing more than one belt on a multi-belt drive, fit the full set together. Mixing a new belt with used belts of the same profile and length can leave the new belt carrying more than its share of the load. Send us the part number and we will confirm the belt or suggest an equivalent.
Dimensions
- Section
- SPB
- Length
- 2580mm
Frequently asked questions
- What are the dimensions of the Movendis P-SPB2580?
- It is an SPB profile narrow wedge V-belt, 2580 mm long, with a 16.3 mm top width, 13 mm height and a 40-degree angle.
- What should I check on the drive before fitting this belt?
- Inspect the sheave grooves for wear, rust, oil and debris, check alignment between the sheaves, and confirm the shafts and bearings turn freely. Then tension the belt to the drive manufacturer's specification.
- How do I request a quote for the P-SPB2580?
- Send the part number by WhatsApp or email. If you are not certain it is the right belt, include the belt marking, the profile and the length so we can confirm it or suggest an equivalent.