V-belt Movendis P-B63.75
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-B63.75 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-B63.75 and any equivalents.
The Movendis P-B63.75 is a classical wrapped V-belt in a B profile with a 1620 mm length. It is built for standard industrial drives where a wrapped classical belt is the specified replacement. Use the dimensions and profile below to confirm it matches the belt you are replacing.
The most reliable way to match this belt is to read the marking on the back of the belt you are removing. Compare the profile letter and the length to the P-B63.75: B profile, 1620 mm. Its top width is 17 mm, its height is 11 mm, and the included angle is 40 degrees. These figures let you check the belt against the pulley groove before you order.
If the old marking is worn or unreadable, measure the belt instead. A classical V-belt is measured by its length, and the profile is set by the cross-section. Confirm the top width and height against the 17 mm and 11 mm of this belt, and check that the drive uses a B-section groove. A belt that sits too high or too low in the groove will not transmit load correctly.
Before fitting a replacement, inspect the drive. Look for worn or misaligned pulleys, damaged grooves, and belts that have been running hot or slipping. Replace belts in sets where the drive uses more than one belt, so all belts share the load evenly. If you are unsure of the correct profile or length, send the belt marking and a photo of the drive for confirmation.
Dimensions
- Section
- B
- Length
- 1620mm
Frequently asked questions
- How do I confirm the P-B63.75 is the right belt?
- Read the marking on the back of the belt you are replacing and compare the profile and length. This belt is a B profile with a 1620 mm length, a top width of 17 mm, a height of 11 mm, and a 40 degree angle.
- What should I send to request a quote?
- Send the part number P-B63.75, or the marking from your old belt, along with the profile and length. A photo of the drive and the pulley grooves helps us confirm the match.
- Can I replace just one belt on a multi-belt drive?
- On drives that use more than one belt, replace the belts as a set so they share the load evenly. Mixing a new belt with worn belts can cause uneven tension and premature wear.