V-belt Movendis P-B472
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-B472 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-B472 and any equivalents.
The Movendis P-B472 is a classical wrapped V-belt in a B profile with a length of 11990 mm. It is built to the standard 40° angle, with a 17 mm top width and 11 mm height. Before you fit this belt, inspect the drive and sheaves so the new belt seats and runs correctly.
Start by locking out the drive and checking sheave grooves for wear, rust, or debris. Worn grooves can let a new classical V-belt sit too deep, which leads to slip and heat. Confirm the sheaves are aligned and that the groove angle matches the belt's 40° angle. Measure the existing belt and compare it to the P-B472: 11990 mm length, B profile, 17 mm top width, and 11 mm height.
Check the sheave diameters and the condition of the bearings and bushings. If the drive uses multiple belts, replace them as a set so the load stays even. Inspect the take-up or tensioning arrangement and make sure it has enough travel for the new belt. Clean the grooves and remove any burrs that could cut the belt wrap.
When you request a quote, send the part number P-B472 and confirm the profile, length, and top width from your old belt. If the marking is worn, share the drive details and photos of the sheaves and nameplate. The team can help confirm the right belt or suggest an equivalent.
Dimensions
- Section
- B
- Length
- 11990mm
Frequently asked questions
- What are the dimensions of the Movendis P-B472?
- It is a classical V-belt with a B profile, 11990 mm length, 17 mm top width, 11 mm height, and a 40° angle.
- What should I check before installing this belt?
- Inspect the sheaves for groove wear, alignment, and debris. Confirm the groove angle matches the belt's 40° angle and that the tensioning travel is sufficient.
- What information do I need to request a quote?
- Send the part number P-B472 and confirm the profile, length, and top width from the old belt. If the marking is unreadable, include drive details and photos.