V-belt Movendis P-B250
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-B250 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-B250 and any equivalents.
The Movendis P-B250 is a classical wrapped V-belt in a B profile. It measures 6350 mm in length, with a 17 mm top width, 11 mm height and a 40-degree angle. Use these four dimensions to match it to the belt you are replacing.
To match the P-B250, read the marking on the back of the old belt. Confirm the profile is B, the length is 6350 mm, and the cross-section is 17 mm by 11 mm. The 40-degree angle is the standard V profile for this belt. If all four values match, the P-B250 is the correct replacement.
When you send a quote request, include the part number P-B250 and the dimensions from the old belt. If the old marking is worn or unreadable, measure the outside length and the top width with a caliper or tape. The MR team can confirm the right belt or suggest an equivalent based on those measurements.
Classical wrapped V-belts like the P-B250 are used in drives where the sheave groove matches the B profile. Inspect the sheaves for wear or debris before installation, and check belt tension after the first run-in period. Replace belts in sets when a drive uses multiple belts.
Dimensions
- Section
- B
- Length
- 6350mm
Frequently asked questions
- How do I confirm the P-B250 is the right belt for my drive?
- Check the old belt marking for the B profile and 6350 mm length. Also verify the 17 mm top width and 11 mm height. If those match, the P-B250 is the correct size.
- What should I send to request a quote for the P-B250?
- Send the part number P-B250 and, if possible, the dimensions from the belt being replaced. Photos of the old belt marking help the team confirm the match or suggest an equivalent.
- Can I replace just one belt in a multi-belt drive?
- For drives that use multiple belts, replace all belts in the set at the same time. Mixing a new belt with worn belts can cause uneven tension and load sharing.