V-belt Movendis P-B215
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-B215 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-B215 and any equivalents.
The Movendis P-B215 is a classical wrapped V-belt in a B profile. It measures 5460 mm in length, with a 17 mm top width, 11 mm height and a 40-degree angle. Use these dimensions to match it against the belt you are replacing.
Start with the marking on the back of the old belt. If it shows a B profile and a 5460 mm length, the P-B215 is the direct size match. Confirm the top width of 17 mm and height of 11 mm against the old belt with a caliper, and check the 40-degree angle against the pulley groove.
A wrapped classical V-belt like this one is often used on drives where the belt must run in standard B-section pulleys. When you inspect the drive, look at the pulley grooves for wear and the sheave alignment before fitting a replacement. If the old belt is stretched or glazed, replace it rather than trying to reuse it.
If the marking is worn off, measure the outside length and the cross-section. A belt that measures 5460 mm in length and 17 mm across the top with an 11 mm height matches the P-B215. Send those dimensions and a photo of the old belt for a quote.
Dimensions
- Section
- B
- Length
- 5460mm
Frequently asked questions
- How do I confirm the P-B215 is the right replacement?
- Check the old belt for a B profile marking and a 5460 mm length. Measure the top width at 17 mm and the height at 11 mm. If those match, the P-B215 is the correct size.
- What should I send to request a quote?
- Send the part number P-B215, or the markings from the old belt. If the marking is gone, send the length, top width and height measurements and a photo of the belt cross-section.
- Can I replace just one belt on a multi-belt drive?
- On drives with multiple belts, replacing the full set at the same time helps keep tension even across the grooves. If you are unsure, send the drive details and the old belt marking for confirmation.