V-belt Movendis P-A28.75
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-A28.75 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-A28.75 and any equivalents.
The Movendis P-A28.75 is a classical wrapped V-belt in the A profile. It measures 730 mm in length, with a 13 mm top width, 8 mm height, and a 40-degree angle. This belt is used on drives that call for a classical A-section belt, such as those on industrial machinery and equipment.
To confirm fit, compare the existing belt's profile and length to the P-A28.75. The A profile is a classical cross-section, and the 730 mm length is the outside circumference. The 13 mm top width and 8 mm height are standard for this profile, and the 40-degree angle matches the pulley groove. When the drive specifies an A-section belt of this length, the P-A28.75 is the correct replacement.
Inspect the drive before ordering. Check the pulleys for wear, alignment, and debris. A worn pulley can quickly damage a new belt. If the drive uses multiple belts, replace them as a set to maintain even tension and load sharing. Record the belt marking from the back of the old belt to help verify the profile and length.
Dimensions
- Section
- A
- Length
- 730mm
Frequently asked questions
- How do I confirm that the Movendis P-A28.75 fits my drive?
- Check the old belt for its profile marking and length. The P-A28.75 is an A-profile classical V-belt with a 730 mm length, 13 mm top width, 8 mm height, and 40-degree angle. If these match the drive requirements, it is the correct belt.
- Can I replace just one belt on a multi-belt drive?
- For drives using multiple belts, it is best to replace all belts at the same time. Mixing new and old belts can cause uneven tension and load distribution, which may lead to premature failure.
- What information should I send to request a quote?
- Send the part number P-A28.75, the quantity needed, and any details from the old belt such as the profile and length. If you are unsure, a photo of the belt marking and the drive setup can help us confirm the right belt.