V-belt Movendis P-A160

MOVENDIS P-A160 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-A160 and any equivalents.

The Movendis P-A160 is a classical wrapped V-belt built to the A profile with a 4064 mm length. The 13 mm top width, 8 mm height and 40° angle identify the cross-section and fit, while the length sets the drive center distance. Read the marking on the old belt and match the profile and length before ordering.

Profile and length are the two dimensions that decide whether a classical V-belt will sit correctly in the pulley groove and reach around the drive. The A profile is a standard cross-section, and this belt measures 4064 mm in length. The 13 mm top width and 8 mm height describe the belt's cross-section. The 40° angle is the included angle of the V, which is designed to wedge into the pulley groove.

When replacing a belt, take the profile and length from the marking on the back of the old belt rather than from a general size. Confirm the A profile and the 4064 mm length, then send the part number P-A160 for a quote. If the old belt is worn or the marking is unreadable, measure the top width and the outside length and include those values with your request. We can help confirm the right belt or suggest an equivalent.

This Movendis classical wrapped V-belt is supplied by MR Industrial Accessories for maintenance and replacement work on drives that use the A profile. Belts that run in matched sets should be replaced as a set so the load stays evenly distributed. Inspect the pulleys for wear, misalignment or debris before fitting the new belt, and check the tension after the first run-in period.