V-belt Movendis P-A16
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-A16 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-A16 and any equivalents.
The Movendis P-A16 is a classical wrapped V-belt in profile A. It measures 407 mm in length, with a 13 mm top width, 8 mm height, and a 40° angle. When a drive is down, the marking on the back of the old belt is often the fastest way to identify what to replace.
Start by reading the marking on the old belt. Note the profile letter and the length, then match them to the P-A16. Because this belt is profile A and 407 mm long, confirming both figures on the back of the belt helps you avoid ordering a belt that is close but not correct.
If the marking is worn, measure the old belt across the top and its overall length, then compare those numbers with the P-A16. Profile A, 13 mm top width, 8 mm height, and 407 mm length are the key figures to check. When the drive runs more than one belt, replacing the full set at the same time keeps the load shared evenly across the grooves.
For a quote, send the part number P-A16, the quantity you need, and the drive or equipment it fits. If the old belt marking is hard to read, send a photo of the belt and the pulley area. Our team can confirm the P-A16 or suggest an equivalent so you get the right belt for the job.
Dimensions
- Section
- A
- Length
- 407mm
Frequently asked questions
- How do I confirm the P-A16 is the right belt?
- Read the marking on the back of the old belt and compare it with the P-A16. Check that the profile is A and the length is 407 mm. If the marking is faded, measure the top width and overall length and match them to 13 mm and 407 mm.
- What should I send to request a quote?
- Send the part number P-A16, the quantity required, and the equipment or drive it fits. If you are unsure, include a photo of the old belt marking and the pulley area so we can confirm the profile and length.
- Should I replace all belts on the drive at once?
- When a drive uses multiple belts, replacing the full set at the same time is good practice. Belts wear at different rates, and mixing old and new belts can cause uneven load sharing across the grooves.